13-42
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 13 Maintain the Node
NTP-G135 Edit Network Element Defaults
NTP-G135 Edit Network Element Defaults
Note
For a list of NE defaults, see
Appendix D, “Network Element Defaults.”
Step 1
Complete the
“DLP-G46 Log into CTC” task on page 2-25
at the node where you want to edit NE
defaults.
Step 2
Click the
Provisioning > Defaults
tabs.
Step 3
Under Defaults Selector, choose either a card (if editing card-level defaults) or NODE (if editing
node-level defaults). Clicking on the node name (at the top of the Defaults Selector column) lists all
available NE defaults (both node- and card-level) under Default Name.
Step 4
Locate a default that you want to change under Default Name.
Step 5
Click in the
Default Value
column for the default property that you are changing and either choose a
value from the drop-down list (when available), or type in the desired new value.
Note
If you click
Reset
before you click
Apply
,
all values will return to their original settings.
Step 6
Click
Apply
(click in the
Default Name
column to activate the Apply button if it is unavailable). You
can modify multiple default values before applying the changes.
A pencil icon will appear next to any default value that will be changed as a result of editing the defaults
file.
Step 7
If you are modifying node-level defaults, a dialog box appears telling you that defaults were successfully
applied to the node. Click
Yes
.
If you are modifying the IIOP Listener Port setting, a dialog box appears warning you that the node will
reboot and asks if you want to continue. Click
Yes
.
Note
Changes to most node defaults reprovision the node when you click Apply. Changes made to
card settings using the Defaults Editor do not change the settings for cards that are already
installed or slots that are preprovisioned for cards, but rather, change only cards that are installed
or preprovisioned thereafter. To change settings for installed cards or preprovisioned slots, see
Chapter 11, “Change DWDM Card Settings.”
To change settings for transponder or muxponder
cards see
Chapter 5, “Provision Transponder and Muxponder Cards.”
Purpose
This procedure edits the factory-configured NE defaults using the NE
Defaults editor. The new defaults can be applied to the node where they are
edited, or exported to a file to be imported for use on other nodes.
Tools/Equipment
None
Prerequisite Procedures
None
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Superuser
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...