1-51
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
August 2005
Chapter 1 Install the Shelf and Common Control Cards
DLP-G21 Install Timing Wires on the MIC-C/T/P (ETSI Only)
DLP-G21 Install Timing Wires on the MIC-C/T/P (ETSI Only)
Step 1
Using coaxial cable with 1.0/2.3 miniature coax connectors, connect the clock cable to the appropriate
connector on the faceplate of the MIC-C/T/P.
Step 2
Gently push the cable with the 1.0/2.3 miniature coax connector down until the cable connector slides
into the 1.0/2.3 miniature coax connector on the faceplate with a click.
The MIC-C/T/P provides 1.0/2.3 miniature coax connectors that are used for timing input and output.
The top connectors are for “A” (BITS-1) timing, and the bottom connectors are for “B” (BITS-2) timing.
In each case, the left connector is the input and the right connector is the output. The input connectors
for timing provide a 75-ohm termination. System cables are available that can convert timing clocks
from 75 ohms to 100/120 ohms.
shows MIC-C/T/P pin assignments.
A high-impedance option (> 3 kilo-ohms or greater) is possible through a jumper on the MIC-C/T/P
FMEC. You can change the top timing input to high impedance by removing the jumper on P3 of the
MIC-C/T/P FMEC. You can change the bottom timing input to high impedance by removing the jumper
on P2 on the MIC-C/T/P FMEC.
Note
Refer to ITU-T G.813
for rules about provisioning timing references.
Step 3
Connect the other end of the cable to the external source of the timing signal according to
Step 4
Repeat
for each cable that is required.
Step 5
Return to your originating procedure (NTP).
Purpose
This task installs the timing cables on the ONS 15454 ETSI MIC-C/T/P.
Tools/Equipment
75-ohm coaxial cable with a 1.0/2.3 miniature coax connector on the
MIC-C/T/P side
Prerequisite Procedures
NTP-G6 Install the MIC-A/P and MIC-T/C/P FMECs (ETSI Only), page
1-28
Required/As Needed
As needed
Onsite/Remote
Onsite
Security Level
None
Table 1-4
MIC-C/T/P Clock Connector Pin Assignment
Pin
Function
IN 1
Input from external device
OUT 1
Output to external device
IN 2
Input from external device
OUT 2
Output to external device
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...
