5-73
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 5 Provision Transponder and Muxponder Cards
DLP-G239 Change Section Trace Settings for MXP_MR_2.5G and MXPP_MR_2.5G Cards
Step 4
Click
Apply
.
Step 5
Return to your originating procedure (NTP).
DLP-G239 Change Section Trace Settings for MXP_MR_2.5G and
MXPP_MR_2.5G Cards
Step 1
In node view, double-click the MXP_MR_2.5G or MXPP_MR_2.5G card where you want to change the
section trace settings.
ALS Mode
Sets the ALS function mode. The DWDM
transmitter supports ALS according to
ITU-T G.644 (06/99). ALS can be disabled or
can be set for one of three mode options.
•
Disable (default): ALS is off; the laser is not
automatically shut down when traffic outages (LOS)
occur.
•
Auto Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur. It
automatically restarts when the conditions that
caused the outage are resolved.
•
Manual Restart: ALS is on; the laser automatically
shuts down when traffic outages (LOS) occur.
However, the laser must be manually restarted when
conditions that caused the outage are resolved.
•
Manual Restart for Test: Manually restarts the laser
for testing.
ProvidesSync
Sets the ProvidesSync card parameter. If
checked, the card is provisioned as an NE timing
reference.
Checked or unchecked
SyncMsgIn
Sets the EnableSync card parameter. Enables
synchronization status messages (S1 byte), which
allow the node to choose the best timing source.
Checked or unchecked
Send
DoNotUse
Sets the Send DoNotUse card state. When
checked, sends a DUS message on the S1 byte.
Checked or unchecked
1.
SF BER and SD BER thresholds apply only to trunk ports (Port 9 for MXP_MR_2.5G and Ports 9 and 10 for MXPP_MR_2.5G).
Purpose
This task changes the section trace settings for MXP_MR_2.5G and
MXPP_MR_2.5G muxponder cards.
Tools/Equipment
None
Prerequisite Procedures
DLP-G46 Log into CTC, page 2-25
Required/As Needed
As needed
Onsite/Remote
Onsite or remote
Security Level
Provisioning or higher
Table 5-44
MXP_MR_2.5G and MXPP_MR_2.5G Muxponder Card Line SONET or SDH Tab Settings (continued)
Parameter
Description
Options
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...