12-5
Cisco ONS 15454 DWDM Installation and Operations Guide, R6.0
September 2005
Chapter 12 Add and Remove Cards and Nodes
NTP-G127 Add an AD-xC-xx.x Card to an OADM Node
NTP-G127 Add an AD-xC-xx.x Card to an OADM Node
Note
Do not begin this procedure until the Cisco MetroPlanner site plan has been recalculated with the new
AD-xCxx.x card added to the OADM node.
Note
During this procedure, you will use TL1 commands to delete and recreate optical channel network
connection (OCHNC) cross-connects. You might need to refer to the
Cisco ONS SONET TL1 Command
Guide
or the
Cisco ONS 15454 SDH TL1 Command Guide
Caution
This procedure will affect the service of unprotected circuits that pass through the OADM node.
Step 1
Complete the
“DLP-G46 Log into CTC” task on page 2-25
at a node on the OADM network.
Step 2
In node view, display the OADM node where you will add the card.
Step 3
Click the
Circuits
tab.
Step 4
Make a list of all OCHNCs that are carried on the express path for both east-to-west (E > W) and
west-to-east (W > E) directions.
Step 5
For OCHNCs identified in
that are routed on the active path of a splitter or Y-cable protection
group, force the traffic to the protect path in the opposite side of the ring using the
Force Y-Cable or Splitter Protection Switch” task on page 10-35
Step 6
Click the
Circuits
tab.
Step 7
Complete the following steps for all OCHNCs carried on the express path that were identified in
:
a.
Choose the OCHNC circuit(s) and click
Edit
. (To choose multiple circuits, press the Shift key while
you click the circuits.)
b.
In the Edit Circuit dialog box, click the
State
tab.
c.
In the Target Circuit Admin State drop-down list, choose
OOS,DSBLD
(ANSI) or
Locked,disabled
(ETSI).
d.
Click
Apply
.
e.
Repeat Steps
through
for each OCHNC circuit.
Step 8
From the Tools menu, choose
Open TL1 Session
.
Purpose
This procedure adds an AD-xC-xx.x card to an optical add/drop
multiplexing (OADM) node.
Tools/Equipment
None
Prerequisite Procedures
A Cisco MetroPlanner OADM site plan recalculated for the new OADM
card
Required/As Needed
As needed
Onsite/Remote
Onsite
Security Level
Provisioning or higher
Summary of Contents for ONS 15454 DWDM
Page 38: ...Figures xxxviii Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 54: ...Procedures liv Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 ...
Page 64: ... 64 Cisco ONS 15454 DWDM Installation and Operations Guide R6 0 August 2005 Chapter ...
