Figure 55: Highlighted Environmental Alarms
Step 2
Return to your originating procedure (NTP).
DLP-G24 Install Timing Wires on the Backplane (ANSI Only)
This task installs the BITS timing wires on the ONS 15454 ANSI backplane.
Purpose
Wire wrapper
100-ohm shielded BITS clock cable pair #22 or #24 AWG (0.51 mm² or 0.64
mm²), twisted-pair T1-type
Tools/Equipment
NTP-G5 Remove the Backplane Covers (ANSI Only), on page 63
Prerequisite Procedures
As needed
Required/As Needed
Onsite
Onsite/Remote
None
Security Level
Procedure
Step 1
Using 100-ohm shielded BITS clock cable #22 or #24 AWG (0.51 mm² or 0.64 mm²), twisted-pair T1-type,
wrap the clock wires on the appropriate wire-wrap pins according to local site practice.
Ground the shield of the BITS input cable at the BITS end. For BITS output, wrap the ground shield of the
BITS cable to the frame ground pin (FG1) located beneath the column of BITS pins.
Timing Pin Assignments, on page 98
lists the pin assignments for the BITS timing pin fields.
Table 18: External Timing Pin Assignments for BITS
Function
CTC/TL1 Name
Tip/Ring
BITS Pin
Input from BITS device 1
BITS-1
ring
A4
Input from BITS device 1
BITS-1
tip
B4
Output to external device 1
BITS-1
ring
A3
Output to external device 1
BITS-1
tip
B3
Cisco ONS 15454 Hardware Installation Guide
109
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
DLP-G24 Install Timing Wires on the Backplane (ANSI Only)
Summary of Contents for ONS 15454
