1-22
Cisco ONS 15454 DWDM Procedure Guide, Release 9.2
78-19286-01
Chapter 1 Install the Cisco ONS 15454 Shelf Assembly
Required Tools and Equipment (ETSI)
Figure 1-8
Positioning the Mounting Brackets for Deep Door Configuration
Step 11
Repeat for the other side of the assembly.
NTP-G3 Open and Remove the Front Door
Step 1
Complete the
“DLP-G9 Open the Front Cabinet Compartment (Door)” task on page 1-23
Step 2
Complete the
“DLP-G10 Remove the Front Door” task on page 1-24
Step 3
If you are using an ETSI shelf, continue with the
“NTP-G4 Open and Remove the FMEC Cover (ETSI
. If you are using an ANSI shelf, continue with the
Backplane Covers (ANSI Only)” procedure on page 1-29
.
Purpose
This procedure opens and removes the front door to access the equipment.
Tools/Equipment
Open-end wrench
Pinned hex (Allen) key
Prerequisite Procedures
NTP-G306 Install the ONS 15454 Shelf Assembly, page 1-8
Required/As Needed
Required
Onsite/Remote
Onsite
Security Level
None
240850
80 mm
80 mm
Side View
Front
Front
Summary of Contents for ONS 15454
