5-24
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
Configuring a Channelized T3 Link
•
The example that follows is for a port adapter in slot 1 of the Cisco 7200 series routers:
Router(config)#
controller T3 1/0
Router(config-controller)#
no t1 10 bert
This completes the procedures for configuring and testing T1 lines.
To check your configurations using
show
commands, proceed to the
; otherwise, proceed to the following sections to perform a basic interface
configuration:
•
Performing a Basic Serial Interface Configuration, page 5-24
Performing a Basic Serial Interface Configuration
Note
The Cisco 7200 VXR Port Adapter Jacket Card requires no configuration. Configure a port adapter in it
as you would any other port adapter.
Following are instructions for a basic configuration: enabling an interface and specifying IP routing. You
might also need to enter other configuration subcommands, depending on the requirements for your
system configuration and the protocols you plan to route on the interface. For complete descriptions of
configuration subcommands and the configuration options available for
serial
interfaces, refer to the
appropriate software documentation.
In the following procedure, press the
Return
key after each step unless otherwise noted. At any time you
can exit the privileged level and return to the user level by entering
disable
at the prompt as follows:
Router#
disable
Router>
Step 1
Enter configuration mode and specify that the console terminal is the source of the configuration
subcommands, as follows:
Router#
configuration terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#
Step 2
Specify the first interface to configure by entering the
interface serial
subcommand, followed by the
interface address of the interface you plan to configure.
provides examples.
