5-43
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
Checking the Configuration
T1 5 - Remote Performance Data (Not available)
T1 6 - Remote Performance Data (Not available)
•
The example that follows is for a port adapter in slot 1 of a Cisco 7200 series router:
Router#
show controllers T3 1/0 remote performance
T3 1/0 is up. Hardware is 2CT3+ single wide port adapter
CT3 H/W Version :1.0.1, CT3 ROM Version :1.1, CT3 F/W Version :2.0.1
FREEDM version:1, reset 0
T1 1 - Remote Performance Data
Data in current interval (640 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
T1 2 - Remote Performance Data
Data in current interval (640 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
T1 3 - Remote Performance Data
Data in current interval (7 seconds elapsed):
0 Line Code Violations, 0 Path Code Violations
0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins
0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs
0 Unavail Secs
T1 4 - Remote Performance Data (Not available)
T1 5 - Remote Performance Data (Not available)
T1 6 - Remote Performance Data (Not available)
.
.
.
(additional displayed text not shown)
Note
If you do not first enable remote performance data with the
t1
t1-line-number
fdl ansi
command, the
following is displayed:
T1 1 - Remote Performance Data (Not available)
Note
Although the PA-MC-2T3+ does not support local controlled slip seconds (CSS), remote T1 equipment
may report CSS values and they will be shown in the remote performance reports.
