5-25
PA-MC-2T3+ Multi-Channel T3 Port Adapter Installation and Configuration
OL-3526-05
Chapter 5 Configuring Channelized mode for the Cisco PA-MC-2T3+
Configuring a Channelized T3 Link
Step 3
Assign an IP address and subnet mask to the interface (if IP routing is enabled on the system) by using
the
ip address
subcommand, as in the following example:
Router(config-if)#
ip address 10.0.0.0 10.255.255.255
Step 4
Add any additional configuration subcommands required to enable routing protocols and set the
interface characteristics.
Step 5
Reenable the interfaces using the
no shutdown
command. (See the
.)
Step 6
Configure all additional port adapter interfaces as required.
Step 7
After including all of the configuration subcommands to complete your configuration, press
Ctrl-Z—
hold down the
Control
key while you press
Z
—or enter
end
or
exit
to exit configuration mode
and return to the EXEC command interpreter prompt.
Table 5-2
Examples of the interface serial Subcommand
Platform
Command
Example
Cisco 7200 series routers
interface serial
, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
The example is for T3 port 0, T1 1,
channel group 0 of a
port adapter in port adapter slot 6.
Router(config)#
interface
serial
6/0/1:0
Router(config-if)#
Cisco 7301 routers
interface serial
, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
The example is for T3 port 0, T1 1,
channel group 0 of a
port adapter in port adapter slot 1.
Router(config)#
interface
serial
1/0/1:0
Router(config-if)#
Cisco 7304 PCI Port Adapter Carrier
Card in a Cisco 7304 router
interface serial
, followed by
port-adapter-slot
/
T3-port/
T1-line-number:channel-group
number
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in a Cisco
7304 PCI Port Adapter Carrier Card in
module slot 3 of a Cisco 7304 router.
Router(config)#
interface
serial
1/0/1:0
Router(config-if)#
Cisco 7401ASR routers
interface serial
, followed by
port-adapter-slot/T3-port/
T1-line-number:channel-group
number
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in port
adapter slot 1.
Router(config)#
interface
serial
1/0/1:0
Router(config-if)#
VIP in Cisco 7000 series or Cisco 7500
series routers
interface serial
, followed by
interface-processor-slot/
port-adapter-slot/
T3-port/T1-line-number:
channel-group number
The example is for T3 port 0, T1 1,
channel group 0 of a port adapter in port
adapter slot 1 of a VIP in interface processor
slot 4.
Router(config)#
interface
serial
4/1/0/1:0
Router(config-if)#
