3-3
Cisco PIX Device Manager Installation Guide
78-15483-01
Chapter 3 Installing PDM
Installing PDM
Step 7
Set the values in the following table:
Step 8
Click OK to continue.
The HyperTerminal window is now ready to receive information from the PIX Firewall console. Wait
30 seconds for the PIX Firewall startup messages to display. These messages should appear similar to
the following example:
Rebooting....
Cisco Secure PIX Firewall BIOS (4.0) #0: Thu Mar 2 22:59:20 PST 2000
Platform PIX-515
Flash=i28F640J5 @ 0x300
Use BREAK or ESC to interrupt flash boot.
Use SPACE to begin flash boot immediately.
Reading 1507840 bytes of image from flash.
#############################################################################
64MB RAM
Flash=i28F640J5 @ 0x300
BIOS Flash=AT29C257 @ 0xfffd8000
mcwa i82559 Ethernet at irq 10 MAC: 0050.54ff.3772
mcwa i82559 Ethernet at irq 7 MAC: 0050.54ff.3773
mcwa i82559 Ethernet at irq 11 MAC: 00d0.b792.409d
-----------------------------------------------------------------------
|| ||
|| ||
|||| ||||
..:||||||:..:||||||:..
c i s c o S y s t e m s
Private Internet eXchange
-----------------------------------------------------------------------
Cisco PIX Firewall
Cisco PIX Firewall Version 6.3
Licensed Features:
Failover: Enabled
VPN-DES: Enabled
VPN-3DES: Enabled
Maximum Interfaces: 6
Cut-through Proxy: Enabled
Guards: Enabled
URL-filtering: Enabled
Inside Hosts: Unlimited
Throughput: Unlimited
IKE peers: Unlimited
Step 9
Press the Enter key if it takes more than a minute for the PIX Firewall command prompt to appear.
If irrelevant characters appear, reset the Bits per second to 9600 and try to connect again.
Field Name
Value to Set
Bits per second
9600
Data bits
8
Parity
None
Stop bits
1
Flow control
Hardware