Chapter 3 Operation using ICIM
68
78-4015908-01 Rev F
Setting SNMP Trap Receiver Parameters
You can use the SNMP trap receiver parameters to specify up to five IP addresses to
which proprietary traps will be sent. You can also specify the events that will result
in a trap being sent to the network management systems at these IP addresses.
The Cold Start trap will always be sent to all network management systems. The
Authentication Failure trap will also be sent to all trap receivers if the
snmpEnableAuthenTraps is set to Enabled.
You can specify which enterprise specific traps are sent to each trap receiver by
setting variables in the P2TrapRecv table.
To Set Traps for a Specific IP Address using P2TrapRecvEntry
Entries to the P2TrapRecvEntry file can be made to send the trap information to a
trap handler. The SNMP agent automatically sends an alert when the value of an
object changes or exceeds a predefined threshold.
1
On an SNMP manager, go to the P2TrapRecvEntry table.
2
Type the IP address to which you want the trap sent.
3
Select
Enable
from the drop-down list.
Result:
The new IP address is enabled and traps are sent to this IP address. Any
changes are immediately stored to the EEPROM, so the changes are not lost if
power is lost or the ICIM is reset.
