If a Cisco external power system is not connected to the switch, install the provided connector cover on
the back of the switch. Statement 386
Warning
Installing or Replacing an AC Power Supply
Procedure
Step 1
Turn off the power at its source.
Step 2
Remove the power cord from the power cord retainer.
Step 3
Remove the power cord from the power connector.
Step 4
Press the release latch at the right side of the power supply module inward and slide the power supply out.
Do not leave the power-supply slot open for more than 90 seconds while the switch is operating.
Note
This unit might have more than one power supply connection. All connections must be removed
to de-energize the unit. Statement 1028
Warning
Step 5
Insert the new power supply into the power-supply slot, and gently push it into the slot. The 1025-W
power-supply module extends inches from the switch rear panel.
Figure 3: Inserting the AC-Power Supply in the Switch
Catalyst 6800IA Switch Hardware Installation Guide
4
OL-30278-02
Power Supply Installation
Installing or Replacing an AC Power Supply
