To display the RPD get IPv6 address by Stateful method, use the
show dhcp
command.
R-PHY#show dhcp
Interface
IP-Address
Subnet-Mask
vbh0
2001:93:3:58::d8
ffff:ffff:ffff:ffff::
Details:
--------------------------------------------------------------------------------
Interface:
vbh0
AddrType:
IPv6<Stateful>
TimeServers:
2001:20:1:1::33
TimeOffset:
28800
LogServers:
2001:20:1:1::33
CCAPCores:
2001:93:3:58::1
Configuring PTP
To configure PTP, use the following example as reference:
On cBR-8 router:
interface Loopback1588
ip address 159.159.159.4 255.255.255.255
interface TenGigabitEthernet5/1/3
/* connect to ASR903 */
ip address 192.104.10.4 255.255.255.0
ip route 10.90.3.93 255.255.255.255 192.104.10.93
/* route to ASR903 loopback ip */
ptp clock ordinary domain 0
servo tracking-type R-DTI
clock-port slave-from-903 slave
delay-req interval -4
sync interval -5
sync one-step
transport ipv4 unicast interface Lo1588 negotiation
clock source 10.90.3.93
/* ASR903 loopback ip */
ptp r-dti 1
ptp-domain 0
/* same domain number with ptp server */
clock-port 1
ethernet 1
/* default value is same index with clock-port index, for RPD, ethernet
1=vbh0, ethernet 2=vbh1 */
clock-source 10.90.3.93 gateway 93.3.10.2
/* clock-source is ASR093 loopback ip,
gateway is ASR903 BDI ID for node */
On ASR903 router as PTP master:
ptp clock ordinary domain 0
Cisco Remote PHY Shelf 7200 Software Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
11
Cisco Remote PHY Shelf 7200 Start Up Configuration Guide for Cisco Remote PHY Shelf 7200 Software 1.1
Configuring PTP
Summary of Contents for Remote PHY Shelf 7200
