41
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
OL-18677-10
Caveats
CSCtl00116
Symptoms: Secondary line card member is not added.
Conditions: This issue occurs when line card redundancy is configured and the
line card redundancy group ID is not 0 or 1.
Workaround: Use line card redundancy group ID 0 or 1.
CSCtk82886
Symptoms: The the Cisco RFGW-10 displays secondary control plane DEPI
sessions instead of primary DEPI sessions. The secondary sessions are treated as
primary sessions, thus disrupting the actual primary sessions causing the cable
modems to go offline.
Conditions: This issue occurs when DEPI Path Redundancy (DPR) is configured
and Cisco RFGW-10 works in conjuction with the Cisco uBR10012 router
running Cisco IOS Release 12.2(33)SCE1. The issue was triggered after a PRE
switchover on the Cisco uBR10012 router.
Workaround: There is no workaround.
CSCtn09101
Symptoms: Traceback and error messages are seen on the Cisco RFGW-10 when
depi eqam-stats
is executed and a line card switchover occurs on the peer CMTS.
Conditions: This issue when
depi eqam-stats
is executed and protect DEPI tunnel
with more than 24 channels is configured on the Cisco RFGW-10, and the peer
CMTS does a DEPI Path Redundancy (DPR) line card switchover.
Workaround: Execute
no depi eqam-stats
command to disable EQAM statistics
information sent to the CMTS router.
CSCtn15255
Symptom: Tracebacks and error messages are observed on the Cisco RFGW0-10
when DEPI sessions are present.
Conditions: This issue occurs when both primary and secondary DEPI sessions
are present.
Workaround: There is no workaround.
CSCtn09061
Symptom: The Supervisor crashes after configuring or deconfiguring depi-class
and depi-tunnel commands on the Cisco RFGW-10.
Conditions: This issue occurs when the depi-class commands are entered in a
single instance, and the
exit
command was not issued to return to the global
configuration mode.
Workaround: Do a Manual DEPI configuration.
CSCtn44190
Symptom: The Cisco RFGW-10 DS-48 up-converter cannot output higher RF
power as Cisco RFGW-DS48-1G line card.
Conditions: This issue may occur in scenarios such as 53 dBmV channel power is
requested through the Supervisor CLI, and the measured RF channel power on the
RF switch output is lesser than 52 dBmV. This occurs because the
Cisco RFGW-10 DS-48 line card limits the Cisco RFGW-10 DS-48 up-converter
maximum output power.
Workaround: Reduce the RF channel power setting (for example, for 4:1 stacking,
set the power lower to less than 52 dBmV).
Caveat
Description