46
Release Notes for Cisco RF Gateway 10 in Cisco IOS Release 12.2SQ
OL-18677-10
Caveats
Open Caveats for Cisco IOS Release 12.2(50)SQ
Resolved Caveats for Cisco IOS Release 12.2(50)SQ
Caveat
Description
Command RF
Output Power
DRFI requires support for an 8-dB range of commanded transmit power per
channel below the maximum power supported for the channel (maximum power is
8 dB). The Cisco RFGW-10 is tested to a range of 10 dB of commanded power
below the maximum supported channel power.
Note
The Cisco RFGW-10 CLI allows a commanded RF power range 30 dB
lower than maximum supported channel power (maximum power - 30 dB).
However, a commanded power range below 10 dB of maximum power
supported is not calibrated and may not be accurate.
Caveat
Description
CSCsu27160
Symptoms: The GUI: HTTP CORE process may use a large amount of Supervisor
CPU at web page refresh.
Conditions: This issue occurs when a GUI web browser page is refreshed.
Workaround: There is no workaround.
CSCsv01988
Symptoms: The GUI “Summary” page does not display dual Supervisor interfaces
correctly. The GUI does not display information on the “Summary” page in the
SUP Input B/W or SUP Input Measurement sections.
Conditions: This issue occurs when redundant Supervisor cards are configured.
Workaround: There is no workaround.
CSCta60651
Symptoms: Burst pre-FEC errors are observed on the Cisco RFGW-10 DS-48 line
card.
Conditions: The issue was first observed in Cisco IOS Release 12.2(44)SQ2.
Workaround: There is no workaround.