9
Plug In the Appliance
Plug the female end of the power cable into the power supply on the back panel
of the appliance. Plug the male end into an electrical outlet.
Temporarily Change Your IP Address for Remote
Access
To remotely configure the Cisco S190 using the network connection, you must
temporarily change the IP address of your computer. Alternatively, you can use
the serial console to configure the Cisco S190, without changing the IP address.
If you use the serial console, proceed to section 8 below.
Note
Make a note of your current IP configuration settings because you will
need to revert to these settings after you finish the configuration.
For Windows
Step 1
Connect your laptop to the primary Management Port (labeled M1)
using the
cross over or Ethernet
cable
included in the system box
. The
Cisco S190 appliance uses the M1 Management port only.
Step 2
Go to the Start menu and choose
Control Panel
.
Step 3
Double-click
Network and Sharing Center
.
Step 4
Click
Local Area Connection
and then click
Properties
.
Step 5
Select
Internet Protocol (TCP/IP)
and then click
Properties
.
Step 6
Select
Use the Following IP Address
.
