3
Unmanaged Desktop Switch
The wall-mount slots are two crisscross slots on the bottom panel
of the unmanaged desktop switch.
S
TEP
3
Insert a screw into each hole, leaving a gap between the surface
and the base of the screw head of at least 0.1 inches (3 mm).
S
TEP
4
Place the unmanaged desktop switch wall-mount slots over the
screws and slide the unmanaged desktop switch down until the
screws fit snugly into the wall-mount slots.
S
TEP
5
Connect the unmanaged desktop switch to the other devices by
following the instructions in
Connecting Network Devices
.
For additional information, see
Where to Go From Here
.
Connecting Network Devices
The diagram is an example of a typical network configuration.
To connect network devices
(such as gateways or other switches) to your
unmanaged desktop switch you need one suitable Twisted Pair (TP) cable
for each unit. We recommend Category 5 or better cable for Gigabit
connections.
2
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
miniGBIC1
(Shared with 12)
(Shared with 24)
miniGBIC2
Cisco Small Business
SR2024
24-Port
10/ 100/ 1000 Swit ch
1
2
3
4
5
6
7
8
9
10
11 12 / miniGBIC1
Link/Act
Gigabit
Link/Act
Gigabit
SYSTEM
13
14
15
16
17
18
19
20
21
22
23 24 / miniGBIC2
193803
