Setting up the Interfaces of the Gateway
Setting up the Wireless LAN
SRP 521 VoIP Gateway Administration Guide
29
3
REVIEW DRAFT — CISCO CONFIDENTIAL
Setting up the Wireless LAN
Basic Wireless Settings
The basic settings for wireless networking are set on this page.
There are two ways to configure the wireless network(s) of the gateway, manual
and Wi-Fi Protected Setup. To manually configure the wireless settings, use the
Basic Wireless Settings page.
If you have client devices, such as wireless adapters, that support Wi-Fi Protected
Setup, then you can use Wi-Fi Protected Setup to automatically configure wireless
security for your wireless network(s). To use Wi-Fi Protected Setup, refer to your
wireless adapter's documentation.
STEP 1
Click Interface Setup on the tab and then click WiFi Setting in the navigation pane.
The Basic Wireless Settings page appears.
STEP 2
From the Network Mode menu, you can select the wireless standards running on
your network.
•
If you have Wireless-N, Wireless-G, and Wireless-B devices in your network,
use the default setting, Mixed.
•
If you have only Wireless-G and Wireless-B devices in your network, select
BG-Mixed. If you have only Wireless-N devices, select Wireless-N Only.
•
If you have only Wireless-G devices, select Wireless-G Only.
Field
Description
Enabled Flow
Control
LAN Flow control. To enable flow control, click the
Enable Flow Control box for the LAN interface and click
Submit. Flow control is enabled by default.
Speed Duplex
Network speed settings. The default setting is Auto-
negotiate.
Details of Port
The Details of Port area shows information about your
ports.
