General Troubleshooting
Cannot Access the E-Series Server or NCE
See the
“
Troubleshooting E-Series Server or NCE Access Issues
”
section in the
“
Firmware Management
”
chapter in the
CLI Configuration Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network
Compute Engine, Release 2.x
.
CIMC Hangs
To resolve this problem, do the following:
•
Use IPMI to reboot CIMC. If using IPMI does not resolve the problem, power cycle the E-Series Server.
•
Verify that there is an SD card in the SD0 card slot. The SD card in the SD0 card slot contains the CIMC
software and should always be present.
The below figure shows the location of the SD0 card slot in a single-wide E-Series Server.
Figure 1: Single-Wide E-Series Server
The below figure shows the location of the dual SD card slots in a double-wide E-Series Server.
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
2
Overview
General Troubleshooting