The SD0 card is the lower card, located in the bottom SD card slot.
Note
Figure 2: Front Panel of the Double-Wide E-Series Server
•
Power down the E-Series Server to check whether the SD card has come out of the slot. If it has, reinsert
the SD card. Do the following:
◦
If the E-Series Server is installed in a Cisco 3900 series router, use the
hw-module sm slot oir-stop
command to power down the server, reinsert the SD card, and then use the
hw-module sm slot
oir-start
command to start the server.
◦
If the E-Series Server is installed in a Cisco 2900 series router, power cycle the router.
Do not remove the SD card when the system is in operation.
Note
CIMC Upgrade Fails When Upgrading from Version 2.2 to 3.1.x
If you are running CIMC version 2.2.x, first upgrade to version 2.3.2 and then upgrade to 3.1.x.
If you have already upgraded to CIMC version 3.1.x, type *** to get into the recovery shell and then install
the image 3.1.x from the recovery shell.
Cannot Download the Host Image
To resolve this problem, verify the following:
•
The FTP server on which you want to download the host image is running.
•
The FTP server path to the image files is correct.
Cannot Power on the E-Series Server
To resolve this problem, clear the server's BIOS CMOS memory using the CIMC GUI or the CIMC CLI:
Clearing the BIOS CMOS Using the CIMC GUI
Before You Begin
•
Log into the CIMC GUI as a user with admin privileges.
•
Power off the server.
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
3
Overview
General Troubleshooting
