Procedure
SUMMARY STEPS
1.
Verify that the line speed value is 9600. Use the
show line
command to verify the line speed value:
2.
If the line speed value is correct, verify that the Baud rate value is 9.6K and the terminal type is compatible.
Use the
show detail
command from /bios/server-management to verify the Baud rate and terminal type:
3.
Verify that the Enabled option in Serial over LAN (sol) is configured as no. Use the show detail command
from /sol to verify the sol configuration:
DETAILED STEPS
Step 1
Verify that the line speed value is 9600. Use the
show line
command to verify the line speed value:
Example:
Router#
show line
Tty Line Typ
Tx/Rx
A Modem
Roty AccO AccI
Uses
Noise Overruns
Int
*
0
0 CTY
-
-
-
-
-
9
0
0/0
-
1
1 AUX
9600/9600
-
-
-
-
-
0
0
0/0
-
2
2 TTY
9600/9600
-
-
-
-
-
0
0
0/0
-
131
131 TTY
9600/9600
Step 2
If the line speed value is correct, verify that the Baud rate value is 9.6K and the terminal type is compatible. Use the
show detail
command from /bios/server-management to verify the Baud rate and terminal type:
Example:
router# ucse 2 session imc
CIMC#
scope bios/server-management
CIMC /bios/server-management #
show detail
Set-up parameters:
Assert NMI on PERR: Disabled
Assert NMI on SERR: Disabled
Baud rate: 9.6k
Console redirection: Serial Port A
FRB2 Enable: Enabled
Flow Control: None
OS Boot Watchdog Timer: Disabled
OS Boot Watchdog Timer Policy: Do Nothing
Power Restore Policy: Power On
Terminal type: PC-ANSI
Step 3
Verify that the Enabled option in Serial over LAN (sol) is configured as no. Use the show detail command from /sol to
verify the sol configuration:
Example:
CIMC#
scope sol
CIMC /sol #
show detail
Serial Over LAN:
Enabled: no
Baud Rate(bps): 9600
Troubleshooting Guide for Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine
7
Overview
Host Login and CIMC Login Troubleshooting
