2-11
Cisco VG248 Analog Phone Gateway Software Configuration Guide
OL-1209-02
Chapter 2 Getting Started with the VG248
Configuring Passwords
Step 5
Enter the new value for Media traffic or Control traffic from 0 to 63, using
decimal format.
By default, Media traffic is set to 46, and Control traffic is set to 26. You cannot
change the value for All other traffic; it is set to 0.
Configuring Passwords
The VG248 ships without a set or enabled password. You should enable
passwords to prevent unauthorized access to and control of the VG248. The
VG248 does not support or use user names.
Once you set a password, however, the VG248 requires that you use it, whether
you are accessing the device using the console port, telnet, HTTP, or FTP. When
using the HTTP, you are required to enter the login password if one is set; you
cannot modify any settings when accessing the VG248 using HTTP. When
accessing the VG248 using FTP, the FTP server adopts the highest level of
security currently set. For example, if you have set both a login and enable
password, you must use the enable password to use FTP.
Caution
By default, the VG248 does not have an assigned password. To
avoid unauthorized access, assign passwords to this device.
Configuring the Login Password
The login password enables you or other users to view the current status of the
VG248. To configure the login password, perform these steps:
Step 1
From the main menu, choose Configure.
Step 2
Choose Passwords.
Step 3
Choose Login password.
Step 4
Enter the new password.
