2
VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR Installation Instructions
78-15842-01
Each card also features protection switch solid state relays on the line interfaces, which together with
redundancy logic and relay control added in a Cisco IOS feature set on the MWR 1941-DC router, can
be used to provide T1/E1 Protection Switching between redundant routers in applicable
implementations.
Note
For information on the Cisco MWR 1941-DC router implementations and Cisco IOS software available
for those implementations, see the
Cisco MWR 1941-DC Mobile Wireless Edge Router Software
Configuration Guide
.
The Cisco MWR 1941-DC router provides three WAN interface slots, which allows support for 6
T1/E1s.
Physical Characteristics of the VWIC-2MFT-T1-DIR, VWIC-2MFT-E1-DIR
Each T1/E1 Multiflex VWIC provides two RJ-48C interfaces. You can distinguish between T1 and E1
Drop and Insert interface cards by the labeling on the faceplate, as shown in
Figure 1
and
Figure 2
.
Figure 1
2-Port T1 Multiflex Trunk Interface Card with Drop and Insert and Relays
(VWIC-2MFT-T1-DIR) Front Panel
Figure 2
2-Port E1 Multiflex Trunk Interface Card with Drop and Insert and Relays
(VWIC-2MFT-E1-DIR) Front Panel
Note
The labeling under the port and on the lower left of the card indicates whether it is a T1 or E1 card. Also,
due to limited space, the last dash was omitted from the label on the card (VWIC-2MFT-E1DIR and
VWIC-2MFT-T1DIR).
For information about the LEDs on the T1/E1 Multiflex VWIC, see
Understanding the LEDs, page 12
.
For information about the pinout configuration for the RJ-48C connectors, see
RJ-48C Pinout
Configuration, page 11
.
65781
VWIC
2MFT-T1DIR
AL
LP
CD
CTRLR T1 1
CTRLR T1 0
RJ-48C ports
SEE
MANUAL
BEFORE
INSTALLATION
65782
VWIC
2MFT-E1DIR
AL
LP
CD
CTRLR E1 1
CTRLR E1 0
RJ-48C ports
SEE
MANUAL
BEFORE
INSTALLATION
