Using the WBPN Wireless-N Bridge for Phone Adapters Configuration Utility
Performing Administrative Tasks
Cisco WBPN User Guide
30
2
STEP 3
Click Start PIN.
Note: The Start PIN button must be clicked within two minutes of beginning WPS
PIN configuration on your wireless router or AP.
STEP 4
Click OK to continue. The WBPN should successfully connect to your device. If not,
repeat steps 1 and 2. If the process is still unsuccessful, try using the push-button
configuration described below.
Push-Button Configuration
STEP 1
In the management interface of the WBPN, from the Navigation Menu, choose
Wireless > WPS.
STEP 2
Click Start PBC.
STEP 3
On your wireless router or AP, push the button that allows you to set up WPS. (See
the user documentation for your router or AP for more information on your
particular device.)
Note: The WPS button on your wireless router or AP must be clicked within two
minutes of beginning PBC configuration on the WBPN.
STEP 4
Click OK to continue. The WBPN should successfully connect to your device. If not,
repeat steps 1 and 2. If the process is still unsuccessful, try using the PIN
configuration method described in the previous section.
Performing Administrative Tasks
You can perform various administrative tasks from the management interface. See
the following sections for more information.
Viewing Logs
•
To view logs, from the Navigation Menu, choose Administration > Log.
•
To send logs to a remote server, check Enable Remote Log and enter the IP
address of the server to which to send logs.
•
Click Refresh to view the latest logs, or Clear to delete all logs.
