Configuring the Cisco SPA500S Attendant Console
Setting Up the Cisco SPA500S Attendant Console
Cisco SPA500 Series and WIP310 IP Phone Administration Guide
167
9
In the following example, extension 3500 is used to add
Subscribecontext
to
point to the context. This is entered in the file sip.conf:
[3500]
type=friend
secret=3500
callerid="spa3500"<3500>
nat=no
context=home
mailbox=3500
Subscribecontext=home
...
...
Configuring the Cisco SPA500S
Complete the configuration required for the extensions on your IP PBX and obtain
the following information:
•
IP PBX IP address or other hostname
•
Phone extension numbers
To configure the Cisco SPA500S:
NOTE
Steps 1 through 4 are only required when the
Server Type
field is set to SPA9000.
These steps are not required for other server types such as BroadSoft and
Asterisk.
STEP 1
Connect to the web UI for the phone to which the Cisco SPA500S is connected.
STEP 2
Click
Admin
/
Advanced
on the web UI page.
STEP 3
Click the SIP tab.
STEP 4
Select
yes
from the
CTI Enable
drop-down list.
STEP 5
Click the
Attendant Console
tab.
STEP 6
Select
yes
from the
Unit 1 Enable
drop-down list. If you have installed two Cisco
SPA500S units, also select
yes
from the
Unit 2 Enable
drop-down list.
