Page 8
CISSELL FORM FINISHER
MECHANICAL ADJUSTMENTS
ADJUSTABLE LEVERS - Move back and forth to regulate size of nylon form at waist, hip and
lower positions. Markings on Index plates enable operator to re-set levers to the exact adjustments
for a known garment style or size. Rotate knob on lever clockwise to lock; counter-clockwise 1/4
to 1/2 turn to unlock; move knob
forward to increase size of form, reverse movement to decrease. Avoid excessive tightening or
loosening of knob as this will delay
adjustments and retard production.
WAIST CONTROL - Regulates expansion at waist line --- for finishing short jackets and childrens
garments.
HIP CONTROL - Regulates expansion at hip line --- for finishing sack coats,
medium length jackets, blouses, etc.
LOWER CONTROL - Regulated expansion at bottom --- for finishing topcoats,
overcoats, raincoats, etc.
ARM ZIPPERS (on both sides) - Open, for sleeved garments; close, for sleeveless; or adjust
between open and closed positions to provide required amount of steam and air within sleeves.
FRONT CLAMP - For clamping front edges of sack coats, jackets, overcoats, housecoats, robes,
front-buttoned dresses and blouses, etc.; - raises 5 for smallest childs garment. Front edges must
overlap at least 3 with buttons on outside. (Push lever to lock, squeeze trigger to unlock.)
BACK CLAMP - For clamping rear vent of sack coats, jackets, topcoats, raincoats, overcoats, etc.,
or center kick-pleat in rear panel of skirt. (Push lever to lock, squeeze trigger to unlock.) Separate
vent clamp furnished for holding rear vent of extremely short garments.
FORM - Rotates 360
o
(in either direction) to obtain the most convenient loading position. The back
clamp has two open positions. In the extreme open position, the handle of the back clamp will
strike the timer assembly, when rotated 360
o
. To avoid this, move clamp to intermediate position.
Avoid rotating form for each garment, as this is tiresome and will greatly reduce production. It is
best for the operator to step from front to rear, as required.
SHOULDER ADJUSTMENT - For adjusting width of shoulder to size of garment. (Rotate knob
clockwise to increase width; counter-clockwise to decrease).
Summary of Contents for FFCD
Page 3: ...Page 3 FF FORM FINISHER LOW BASE OVERALL DIMENSIONS...
Page 6: ...Page 6...
Page 16: ...Page 16...
Page 17: ...Page 17...