Page 17
150 lb. Steam Heated Laundry Dryers - Specifications
Dryers must be electrically grounded
by a separate #14 or larger green wire
from the grounding terminal within the Service Connection Box to a cold water
pipe. In all cases, the grounding method must comply with local electrical code
requirements; or in the absence of local codes, with the
National Electrical
Code, ANSI/NFPA 70 or the Canadian Electrical Code, CA C22.1.
See wiring diagram furnished with dryer. Your dryer is completely
wired at the factory and it is only necessary for the electrician to
connect the power leads to the wire connectors with the Service
Connection Box on the rear of the dryer. Do not connect the dryer to
any voltage or current other than that specified on the Dryer Rating
Plate. (Wiring diagrams are located on rear wall of dryer.)
All panels must be in position before operation of dryer.
ELECTRICAL
CONNECTIONS -
ALL DRYERS
(ILLUSTRATION)
GROUNDING
INSTRUCTIONS
«Attention. Lors des opérations dentretien
des commandes, ètiqueter tous les fils avant
de les dèconnecter. Toute erreur de câblage
peut être une source de danger et de panne»
Summary of Contents for HD150.1
