27
TS9000/TS9050 TouchStar Systems User Manual
You must have a keyboard or keyboard emulator previously
attached to the system to perform a warm boot.
Perform a cold boot when the screen is frozen, or the system is
otherwise locked up. The cold boot is essentially a power-up
sequence.
Warm Boot
To perform a warm boot:
1. Press CTRL-ALT-DEL on the keyboard. This causes the
system to reprocess the config.sys and autoexec.bat files.
2. Reload the desired software application, if necessary.
Cold Boot
To perform a cold boot:
1. Remove power from the TouchStar by removing the
power supply from the wall outlet (TS9000), or turning
off the power ON/OFF switch on the DC power con-
verter (TS9050).
2. Turn the power back on by plugging the power supply
back into the wall outlet (TS9000) or turning on the
power ON/OFF switch on the DC power converter
(TS9050).
OR,
3. Push the RESET button on the rear panel of either unit.
OPERATING MODES AND ENVIRONMENTS
The TS9000/TS9050 TouchStar systems can be operated in either
a client-server environment, or in a terminal emulation mode.
Operating software installation is briefly described for each mode.
Client-Server Environment
• Installing The DOS Operating System
If your TouchStar system has not been factory-configured
with a bootable Flash drive, the unit will display the follow-
ing message on power-up after the self-tests have been
completed.
BASIC OPERATION - 3
