Setup Wizard
IMPORTANT 1:
We recommend that you run the setup wizard on initial power-up as the
PBX Type
needs to be set before the unit will become operational, and the phones to initialized. This item can be
accessed at anytime by selecting:
Remote
→
Utilities
→
Setup Wizard
Gateway
→
Utilities
→
Setup Wizard
Setting the Country Code
The country code is used to set a number of region-specific telephony settings in the system including the
operating characteristics for the local Analog Port. It is important to set the region code correctly before
using the Analog Port feature.
When running the setup wizard you will be prompted to change or set the country code. If you don't know
your country code you can enter
?
to display a list of supported countries.
1. Enter the corresponding number and press
Enter
. You will then be prompted to confirm the correct
country name.
2. Enter
Y
if the country is correct or
N
if incorrect. If multiple countries use the same country code the
select N when prompted to confirm will cause the system to display these additional country names
for selection. Select
Y
when the correct country name is displayed.
The EXTender provides a console setup wizard that guides you through many of the required
programming/ configuration required to complete initial setup of the units, via the VT100 management
console accessed through the DB9 management port.
You can access the setup wizard through the console MI. This requires a PC connection to the unit via
the DB9 console port. The wizard requests basics configuration information to establish the initial
configuration programming. You can use the MI to configure parameters that are not configurable through
the wizard.
Standard Console User Interface vs. the Setup Wizard
When a unit is first powered up it checks a Setup Wizard flag. If the flag is set, the standard console UI is
displayed. If the flag is not set, the system prompts you to run the Setup Wizard. After this initial Setup
Wizard prompt, the system sets the Setup Wizard flag to prevent you from receiving this prompt again.
You can access the Setup Wizard through the console MI, if you want to run it later.
How to access the Setup Wizard through the MI
Path:
Remote->Utilities->Setup Wizard
Figure 11: Set Up Wizard
EXTender™ IP6000 Quick Installation Guide
28
