BATTERY INSERTION:
1)
This unit is powered by one 9 volt alkaline battery.
2)
Using a Phillips head (+) screwdriver, remove the battery compartment cover. See
Picture 3.
3)
Insert a fresh 9 volt battery and snap the (+) and (-) terminals to the unit’s battery
clip. Do not try and reverse the terminals. The battery will only fit one way.
4)
Replace the battery compartment cover and tighten the retaining screw.
The unit is now ready for use.
USING THE LISTENING FUNCTION:
1) Plug the headphone into the headphone jack. (See Picture 1)
2) Aim the unit at the desired subject.
3) Squeeze the ON/OFF Switch. You will now hear an amazing wealth of amplified
sound.
THE FREQUENCY CONTROLLER:
When you are listening to amplified sounds you may notice that unwanted
background noises, such as the rumble of traffic, is annoyingly loud.
The Frequency Controller (See Picture 1) can reduce these unwanted sounds.
While listening, simply turn the Frequency Controller dial until you achieve the
desired noise reduction.
RECORDING SOUNDS:
If you have a tape recorder that has a monitor function; that is if the recorder’s
earphone jack let’s you hear sounds as they are being recorded, you can listen to
your subject while you are recording by plugging a patch cord into the OR7008’s
earphone jack and the tape recorder’s LINE IN or MIC jack, and plugging the
headphones into the tape recorder’s EARPHONE jack. Set the tape recorder to
RECORD. You will then be able to record on to tape as long as you hold in the
OR7008’s ON/OFF switch.
Picture 3.
Battery
Compartment Cover