Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 113 -
GS v 0 m xL xH yL yH d1 ... dk
[Function]
Printing of raster bit image
[Code]
<1D>H<76>H<30>H<m><xL><xH><yL><yH> [<d>] k
[Range]
0
≤m≤3, 48≤m≤51, 0≤xL≤255, 0≤xH≤255,
0
≤yL≤255, 0≤yH≤8, 0≤d≤255,
k=(xL+xH×256)×(yL+yH×256), however,
k≠0
[Outline]
[The specification which is common to the model]
• Prints raster bit images in mode “m”.
m
Mode Name
Dot Density in
Vertical Direction
Dot Density in
Horizontal Direction
0, 48
NORMAL MODE
203dpi
203dpi
1, 49
DOUBLE WIDTH MODE
203dpi
101dpi
2, 50
DOUBLE HEIGHT MODE
101dpi
203dpi
3, 51
QUADRUPLE SIZE
MODE
101dpi
101dpi
• xL, xH specify the number of data in horizontal direction of the bit image to (xL+xH×256) bytes.
• yL, yH specify the number of data in vertical direction of the bit image to (yL+yH×256) bytes.
[Caution]
[The specification which is common to the model]
• Any of the print modes (character size, emphasis, double strike, inverting, underlining, back-to-white reversing,
etc.) does not affect the raster bit image.
• If the print area specified by GS L and GS W is narrower than a minimum width, the print area for that line
only is extended to the minimum width. The minimum width is one dot in NORMAL MODE (m=0, 48) and
DOUBLE HEIGHT MODE (m=2, 50), and 2 dots in DOUBLE WIDTH MODE (m=1, 49) and
QUADRUPLE SIZE MODE(m=3, 51).
• Any part of data that is out of the print area is only read and discarded in units of dot.
• The print start position can arbitrarily be specified with HT (horizontal tab), ESC $ (specifying absolute position),
ESC
\
(specifying relative positions), and GS L (setting left margins). Note that if the print start position is not a
multiple of 8, the printing speed may decrease.
• The setting of ESC a (aligning characters) are also valid for the raster bit image.
• If this command is executed during macro definition, the macro definition is suspended, and the processing of
the command starts. The macro is left undefined.
• “d” denotes defined data. Dots to be printed are specified as “1”, and those not to be printed as “0”.
• Valid only when no print data is present in the print buffer at the selection of STANDARD
MODE.
