Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 102 -
GS $ nL nH
[Function]
Specifying the absolute position of character vertical direction in PAGE MODE
[Code]
<1D>H<24>H<nL><nH>
[Range]
0
≤nL≤255, 0≤nH≤255
[Outline]
[The specification which is common to the model]
• Specifies the vertical position of character at the start point of data development in PAGE MODE using
absolute position based on the start position.
• The position of vertical direction of character at the start position of next data development is the position
[(nL+nH×256)×basic calculation pitch] from the start position.
[Caution]
[The specification which is common to the model]
• This command is ignored except at PAGE MODE selection.
• Absolute position setting exceeding the specified print area is ignored.
• Position in horizontal direction of character at the start position of data development is not shifted.
• Start point used as the reference is set by ESC T.
• The following operation occurs at the start point of ESC T.
(1) When start point is set at “upper left” or “lower right”, the absolute position of paper feed direction (vertical
direction of character) is set. In this case, basic calculation pitch (y) of vertical direction is used.
(2) When start point is set at “upper right” or “lower left”, the absolute position of vertical direction of paper
feed (vertical direction of character) is set. In this case, basic calculation pitch (x) of horizontal direction is
used.
• Basic calculation pitch is set by GS P.
• When fractional number is caused by the calculation, it is corrected by the minimum pitch of mechanism and
the rest is discarded.
[See Also]
