Support
model
CT-S280
CT-S300
CT-S2000
CT-S4000
CT-S251
CT-D150/E351
CT-S281
CT-S310
CT-S801/851
CT-S601/651
CT-P29x series
CT-S310II
CT-D151/E651
- 64 -
FF (At selection of PAGE MODE)
[Function]
Printing in PAGE MODE and returning to STANDARD MODE (at the selection of PAGE MODE)
[Code]
<0C>H
[Outline]
[The specification which is common to the model]
• Executes a batch printout of the data mapped in the entire print area, and then returns to STANDARD
MODE.
[Caution]
[The specification which is common to the model]
• All mapped data is erased after printout.
• The print area set up by ESC W is initialized.
• This command does not execute a paper cut.
• After this command is executed, the beginning of the line is taken as the start position for the next print.
• This command is only effective when the PAGE MODE is selected.
CT-S4000
• When selecting BM paper or label paper to specify the PAGE MODE, data extended to all
printing area is printed in batch. After returning to the STANDARD MODE, setting the
start position of next label is carried out.
[See Also]
Appendix 5.1.4 “Example of Using PAGE MODE”
