—
Eng 6
—
5. Subsequent Measurement
When a measurement need to be made again, the time
between two measurements must be at least ten minutes.
6. Memory Recall
●
The stored data can be recalled by pressing the memory
recall switch.
●
Up to seven data can be stored.
— Memory recall function does not work during automatic
inflation and blood pressure measurement are being
made.
If the memory recall switch is pressed,
the average values of the all stored
data (systolic blood pressure, dias-
tolic blood pressure, and pulse) are
indicated first.
If the memory recall switch is pressed
further, the newest data are indicated.
If the memory recall switch is pressed
further, the old data are indicated in
the order of the time series.
7. Deletion of Memory Data
— By depressing of “RESET Switch” on the rear side in-
strument, memory data (blood pressure value and
pulse) are all cleared.
8. Automatic Power OFF Function
If this is left on after measurement an “Automatic Power-
OFF Function” turns the power off after approximately 3
minutes. To continue measurement press the “POWER
Switch” turning the units on.
9. Battery Replacement
If the batteries become weak, the “
” mark will appear
in the display, indicating that batteries should be replaced
with new one. Dispose of the dead batteries properly to
preserve the environment.
Remove the battery cover at main-
frame and replace the four pieces of
batteries.
Type “AA” battery or equivalent is
suitable for this blood pressure moni-
tor.
STAR
T
SYSTO
LIC
mmHg
mmHg
MEMORY
DIAS
TOLIC
PLUS
E
POW
ER
STAR
T
SYST
OLIC
mmHg
mmHg
MEM
ORY
DIASTOLIC
PLUSE
POW
ER
AVG
1
2
3
4
6
7
1
2
3
4
1
2
3
4
