-E32-
# < x value > [ x ] < Number of repeats > [ 2nd ] [ DEL ]
(B) To delete paired–variable / regression data using the following
syntaxes:
# Individual data-set : < x value > [ ] < y value > [ 2nd ] [ DEL ]
# Multiple data-set with the same value :
< x value > [ ] < y value > [ x ] < Number of repeats > [ 2nd ]
[ DEL ]
If you enter and delete a value that isn't included in the stored data by
mistake, " dEL Error " appears, but the previous data are still retained.
Editing data
Press [ 2nd ] [ EDIT ] to enter EDIT mode. The EDIT mode is
convenient and friendly for you to view, correct, delete data.
(A) In 1–VAR mode, the method to view data depends on whether you
want to view data item or not.
# Each time you press [ DATA ], first data item appears 1 second
and then the corresponding value.
[ DATA ]
DEG
dAtA 1
STAT
EDIT
1 second
DEG
15.
STAT
EDIT
# Each time you press [
], value appears directly on the
display without data item.
[
]
DEG
15.
STAT
EDIT
(B) In REG mode, each time you press [ DATA ], data item and x value
appear on the screen at the same time. You can press [ ] to
switch between x and y value.
[ DATA ]
DEG
DATA 1 = 15 , 45
STAT
15
EDIT
[
]
DEG
DATA 1 = 15 , 45
STAT
451
EDIT
If you want to correct data, find out and enter a new entry to replace it.
FULL message
A “ FULL” is indicated when any of the following conditions occur and
further data entry becomes impossible. Just pressing any key can
clear the indicator. The previous data entries are still retained unless
you exit STAT mode.
1) If the times of data entry by [ DATA ] is more than 50
2) The number of repeats is more than 255
