86
Driving
)
Turn thumb wheel
1
to the
"LIMIT"
position: the speed limiter mode
is selected but is not switched on
(PAUSE).
You do not have to switch the speed limiter
on in order to set the speed.
Programming
Leaving limiter mode
)
Turn thumb wheel
1
to the
"0"
position:
the speed limiter mode is deselected. The
display returns to the distance recorder.
On a steep descent or in the event of
sharp acceleration, the speed limiter will
not be able to prevent the vehicle from
exceeding the programmed speed.
To avoid any risk of jamming of the
pedals:
-
ensure that the mat is positioned
correctly,
-
do not fit one mat on top of another.
In the event of a speed limiter fault, the speed
is cleared resulting in flashing of the dashes.
Have it checked by a CITROËN dealer or a
qualified workshop.
Operating fault
)
Set the speed value by pressing button
2
or
3
(e.g.: 55 mph
(90 km/h)).
You can then change the programmed speed using buttons
2
and
3
:
-
by + or - 1 mph (km/h) = short press,
-
by + or - 5 mph (km/h) = long press,
-
in steps of + or - 5 mph (km/h) = maintained press.
Exceeding the programmed speed
Pressing the accelerator pedal to exceed the programmed speed will not have
any effect unless you press the pedal
firmly
past the
y
point of resistance
.
The speed limiter is deactivated temporarily and the programmed
speed, which is still displayed, flashes.
Returning to the programmed speed, by means of intentional or unintentional
deceleration of the vehicle, automatically cancels the flashing of the
programmed speed.
)
Switch the speed limiter back on by pressing button
4
again.
)
Switch the speed limiter on by pressing button
4
.
)
Switch the speed limiter off by pressing button
4
: the display
confirms that it has been switched off (PAUSE).
Summary of Contents for 2012 C-ELYSEE
