1. Pull out antenna A & B. Make them to be perpendicular with the machine.
2. Connect input connector of AC/DC adapter to power source. Connect
output connector to receiver rear panel DC input jack (8).
Make sure the power source voltage is same as marked voltage on the
rear panel
3. Connect one end of attached audio cable to the unbalanced output jack(7)
of the receiver. Connect the other end of the cable to "line in" input jack of
amplifier.
4. Turn on power switch, LCD panel will light.
5. Press UP or down button to set the receiver frequency same as transmitter
frequency.
6. Turn on transmitter power switch, "RF" indicator of the receiver will display
Volume of the receiver can be controlled by adjusting the volume knob.
Attention
When installing the receiver, locate the receiver at least 1m above the ground
and 1m beyond the wall. Antennae should be extended fully to get the
the reception signal.
3.OPERATION OF THE RECEIVER
4. TRANSMITTER PARTS DESCRIPTION
1. MIC head: capsule inside.
2. Power switch
3. LCD Display: display channel no., Frequency and battery life.
4. Channel Selector
5. Colorful ring. It is for distinguishing different microphones.
6. Battery compartment.