4
17. CUE BUTTON
–Pressing the CUE button during playback immediately pauses playback and returns the
track to the last set cue point. The CUE LED will glow when the unit is in cue mode. The LED will also flash
every time a new CUE POINT is set. The CUE button can be held down to momentarily play the music.
When you release the CUE button it instantly returns to the CUE POINT. You can also tap the CUE button
to create a STUTTER EFFECT.
18. JOG WHEEL
– This jog wheel serves 3 functions depending on the mode you are working in.
The wheel works as a pitch bend during Playback. Turning the wheel clockwise can increase the pitch
percentage up to 100%, and turning the wheel in the counterclockwise direction can decrease the pitch
percentage down to -100%. The pitch bend will be determined on how long you turn the jog wheel
continuously.
The jog wheel acts as a slow frame search (1/75 sec) control when the music is not playing but either paused
or set to a cue point. To set a new cue point, spin the wheel then press PLAY or IN when you have
determined the proper position. Press CUE to return to the “CUE POINT”.
If the search function is active, you will be able to search at a higher speed through all the tracks.
19. POWER SWITCH button
– It is used to switch the power on/ standby. When power cord plug into the rear
socket to be the STANDBY mode, all LED are off but STANDBY LED.
(a) In the STANDBY mode, press power button to POWER ON,” Please insert memory device” is
displayed in the LCD.
(b) In the POWER ON mode, press and hold the power button more than 2sec. to standby.
20. TEMPO LOCK BUTTON
– This button is used to choose the tempo lock mode and the pitch control mode.
Tempo lock mode allows speeding up or slow down playback speed without altering the tonality of music.
21. SGL/CTN BUTTON
– You can choose between “single track mode” and “continuous play”.
Continuous play:
the complete memory device will be played without interruption. (mostly used in pubs)
Single track:
player stops at the end of each track and waits at the beginning of the next track. (mostly
used by deejays) Push the SGL/CTN button for more than 1 second to switch between normal and “auto
cue” mode. See basic operation for more information.
22. POWER CONNECTOR
– Plug in power adapter here. It is a switching adapter to suitable to each voltage.
23. FADER START
– This connection allows two players to be linked for relay play. This can also be
connected to a mixing board that supports automatic fader start.
24. AUDIO OUTPUTS
–Output for the audio signals is from each player. Use the supplied cinch/cinch cables to
connect these outputs to the CD/line inputs of your mixing unit.
CONTROLS AND FUNCTIONS
CONTROL UNIT
