Page 6
Anderson 45A Power Pole DC Power Dimmer Output Connectors (/Blue -): These
are the +VDC dimmed outputs for the QolorFLEX 3x10A Dimmer, and are labelled A, B and
C. They mate directly with 30A and 45A Anderson Power Pole connectors. Note that for each
dimmer channel the Blue – output is the pulse width modulated (PWM) output, while the
output is the constant power output. The QolorFLEX 3x10A Dimmer is capable of
outputting up to 30 amps of DC power, so be sure that the connected output power wiring is
up to the task!
Reset Switch: This little recessed switch resets the Microcontroller in the QolorFLEX 3x10A
Dimmer. Use a paper clip or other small object to press if required.
5P XLR Male Connector: DMX/RDM Input. Connect your DMX512 source here using any
ESTA compliant DMX512 cable.
5P XLR Female Connector: DMX/RDM Pass-Thru/Output. When the Transmitter is
connected to a conventional DMX controller, this connector serves as a DMX pass-thru.
DMX Termination Switch: The QolorFLEX 3x10A Dimmer DMX Input is provided with a
conventional manual termination switch. Switch the handle to ON for end-of line DMX
Termination.
The Start Up display reports DMX connection status (“DMX: OK” or “DMX: No Data”).
Press the center ENTER button to access the menus.
Menu:
Address
DMX Start:
Set the Starting DMX address for the Dimmer
RDM Setting
Device Label:
This is an editable field that allows the user to create a
unique alpha-numeric 16 character RDM label for the unit.
Unique ID:
This is a non-editable field that displays the RDM Unique
ID.
Level Tests
Dimmer A Level:
Set Dimmer A to a Level in %
Dimmer B Level:
Set Dimmer B to a Level in %
Dimmer C
Level:
Set Dimmer
C
to
a
Level
in
%
Curve Selection
Dimmer
Curve A:
Select either ISL, Linear, LED, or Non-Dim.
Dimmer Curve B:
Select either ISL, Linear, LED, or Non-Dim.
Dimmer
Curve
C:
Select either
ISL, Linear,
LED,
or
Non-Dim.
