6
Condition
Blink
Pattern
Blinks
followed
by
1sec
pause
UNDER
VOLTAGE
.
.
.
1
INVALID
DMX
ADDRESS
..
..
..
2
INVALID
SHOW
ID
…
…
…
3
OUTPUT
OVER
CURRENT
….
….
….
4
INPUT
OVER
CURRENT
…..
…..
…..
5
OVER
TEMP
……
……
……
6
OVER
VOLTAGE
…….
…….
…….
7
4. Bump Buttons: A bump button is provided for each dimmer output
(Bottom Panel)
5. DMX Addressing DIP Switch (9 position): Set the starting DMX address for the unit
6. Curve Selection DIP Switch (8 position): Select the dimming curve for each of the
individual dimmer outputs in the unit
7. MOD Selection DIP Switch (2 position): Select the PWM modulation frequency for
dimmer channels set to the LED Curve.
8. R DIP Switch (1 position): Setting this Reset switch to ON resets the Dimmer and holds
in reset until set to OFF.
9. T Dip Switch (1 position): Setting this termination switch to ON connects end-of-line
DMX termination.
D4 Dimmer RDM Parameter IDs
The D4 Dimmer supports the all mandatory RDM Parameter IDs (PIDs) plus to following PIDs:
PROXIED_DEVICE_COUNT
PROXIED_DEVICES_ENHANCED
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
FACTORY_DEFAULTS
SOFTWARE_VERSION_LABEL
DMX_BLOCK_ADDRESS
SENSOR_DEFINITION
SENSOR_VALUE
RECORD_SENSORS
OUTPUT_RESPONSE_TIME
OUTPUT_RESPONSE_TIME_DESCRIPTION
MODULATION_FREQUENCY
MODULATION_FREQUENCY_DESCRIPTION
DMX_START_ADDRESS
SLOT_INFO