VI.INSTANDHALTUNG
TIGHTEN THE BELT:
(if the belt slips on the treadmill
when walking). Start treadmill and increase the speed to
3MPH.Using the
5mm Wrench
, turn both bolts 1/4
clockwise. If the belt is properly tight to walk, you must
be able to pull up each side of the belt 5 or 7 cm off the
platform. Be careful and maintain the belt aligned.
Repeat this procedure until the belt is properly
tightened.
if the running belt slips,use 6mm wrench,turn
both sides bolts 1/4 clockwise.Repeat this
procedure until the belt is properly tightened.
TIGHTEN THE DRIVE BELT:
if the drive belt becomes
loose after using for a period of time,you need to:
(1) Open the motor cover .
(2) Use the 5mm wrench to turn the adjusting
bolt clockwise.
Repeat this procedure until the drive belt is not slippery
anymore.
CLEANING:
Don't use abrasive products. A damp cloth is enough.
LEVELING:
If your unit is provided with leveling wheels, please adjust them
in order to avoid vibrations and therefore malfunctions.
KEEP THESE MAINTENANCE ADVISES FOR FUTURE REFERENCES
Adjusting b
o
lt
12
ZIEHEN SIE DEN RIEMEN AN:
(Wenn der Gurt beim
Gehen auf dem Laufband rutscht). Starten Sie das
Laufband und erhöhen Sie die Geschwindigkeit auf
3MPH. Drehen Sie beide Schrauben mit dem
5-mm-Schraubenschlüssel 1/4 im Uhrzeigersinn. Wenn
der Gurt richtig straff ist, müssen Sie in der Lage sein,
jede Seite des Gurtes 5 oder 7 cm von der Plattform
hochzuziehen. Seien Sie vorsichtig und halten Sie den
Riemen ausgerichtet. Wiederholen Sie diesen Vorgang,
bis der Riemen richtig gespannt ist.
ZIEHEN SIE DEN ANTRIEBSRIEMEN AN
:
Wenn sich der
Antriebsriemen nach längerem Gebrauch lockert, müssen Sie:
(1) Öffnen Sie die Motorabdeckung..
(2) Drehen Sie die Einstellschraube mit dem
5-mm-Schlüssel im Uhrzeigersinn.
Wiederh
o
len Sie diesen V
o
rgang, bis der Antriebsriemen
nicht mehr rutschig ist
.
REINIGUNG:
Verwenden Sie keine Scheuermittel. Ein feuchtes Tuch reicht
aus.
NIVELLIEREN:
Wenn Ihr Gerät mit Nivellierrädern ausgestattet ist, stellen
Sie diese bitte ein, um Vibrationen und damit Fehlfunktionen zu vermeiden.
BEHALTEN SIE DIESE WARTUNGSHINWEISE FÜR ZUKÜNFTIGE
REFERENZEN
Wenn der Riemen durchrutscht, verwenden Sie
einen 6-mm-Schraubenschlüssel und drehen
Sie beide Seitenschrauben 1/4 im Uhrzeigersinn.
Wiederholen Sie diesen Vorgang, bis der Riemen
richtig gespannt ist.
Linker
Bolzen
Rechter
Bolzen
Https://www.LikeSporting.com