CK4L-3000B instruction
Shenzhen Createk Electronics
·
www.ckdz.com
·
Tel: +86-755-26643017
·
Fax:
+86-755-26644342
Address
：
Floor 2/3,8 Block,A Area,Tanglang Industry Zone,Xili Town,Nanshan District , 518055, Shenzhen City
Connector: Owen Zhong, E-mail:
zhongke@ckdz.com
, Mobile: +86 13714452125 Page 4 of 26
Safety Notice
！
Dangerous
There‟s high voltage in processor, to avoid dangerous, please do not open rear cap
without authorization.
！
Warning
1.1.
Do not allow liquid, small particles or other objects to get into the equipment;
1.2.
Do not place the system near fire and water;
1.3.
Do not block any vents. To maintain good ventilation, please place the system at least 20 cm
away from a wall surface;
1.4.
If any noise
、
smoke
、
smell, please cut off the power at once and contact your local suppliers;
1.5.
Do not disconnect DVI signal cable when power on.
！
Attention
1.1.
Read the manual carefully before using the system, and keep it for use later;
1.2.
Cut off the power if thunder or long term sleeping;
1.3.
The users should be well trained before operating the system;
1.4.
Do not slip anything from vent to prevent broken or electric shock;
1.5.
Do not place the device near liquid or moisture;
1.6.
Do not put the device near cooling fin or high temperature environment;
1.7.
Keep the power cable proper;
1.8.
If the following situations happen, please cut off the power and for maintenance:
1)
Liquid splash to device;
2)
Device fall down or cabinet is broken;
3)
Any abnormal or malfunction in the system
1.
Model Name
CK4L3000B, CK4L3000BS (built-in optional SDI input&output)
Note: For CK4L3000 B without HDSDI inputs, the words referring to SDI setting is not
available for them.
2.
All types function declaration
There are two models of CK4L3000B series
，
including 3000B and 3000BS
，
the function is
defined as follows:
The table below indicates the function of each different type of products. Please read the
following guide book carefully before your operation.
