CK4L-5000 User Manual
- 7 -
4.2 Front panel operation
Fig. 4.2 Status display when idle
In idle status (The equipment is not operated or controlled within 12 seconds.) The status
display will show the following information:
The 1
st
line: Equipment model
The 2
nd
line: The video wall layout 2x1; there are 1x1, 1x2,2x1,1x3,3x1,1x4,4x1,2x2 total
eight selectable layouts;
The 3
rd
line: correspondence between input and output, Main Window output corresponds
to the input 1, PIP sub-window corresponds to the input 2;
The 4
th
line: Output resolution in the format of X x Y, the value depends on the pixels of
LED screen.
A. Input signal selection
If you want the input 1 to show on window A output, press the front panel button
【
1
】
, the
status display will show the current input 1 ,
【
input 1 to output window __
】
, then press
【
A
】
, therefore, status display shows again
【
input 1 to output window A
】
, the message
means input1 has been already outputted to window A. The input/output Selection
Buttons are also used together with Knob Button when size and position of outputs need
to be adjusted.
B. Preset mode SAVE and RECALL
After on-site configuration for window size, position and layouts, press
【
SAVE
】
button,
then adjust the Knob Button, press
【
ENTER
】
to save the current configuration data to
correspondent number from 1~16.
When need to recall the preset memory that has been saved, press
【
RECALL
】
button,
