ELECTRIC CREAM SEPARATOR FJ 600_v 6 USER`S MANUAL
Page 5
5. ASSEMBLING PROCEDURE
Put the housing with outlets holder on a plain surface.
Put assembled top bowl on the rubber cone fixed on the end of the motor shaft. Knock
slightly on top of the bowl so that it sticks securely on the cone.
Put skimmed milk funnel (conical shape) on the top of the outlet holder and then also
cream funnel (concave shape) on the top of previous one.
Turn top bowl with hand and check if is not touching one of the funnels and adjust
funnels to desired position for skimming.
Place the container holder on the top of both funnels. Place floating device in it. Then
place container on the container holder. Fix all parts together with fixing part with
handle.
Place closing cork in the hole situated in the middle of milk container. The horizontal
bar of the closing cork handle must be turned away from the cut in the container ( see
picture). The milk outflow will be closed.
Fix speed controller on the wall, close to electric socket.
Connect the plug from device in connector on speed controller box ( look picture
B
)
Cut on the container:
1. Open
2.Closed
Fixing part with handle
Please note!
Main cord must be connected to safety outlet with grounded terminal!
Please note!
The closing cork must be closed, when you fill the container. This means that the end of
the closing cork handle must be turned to opposite direction of the cut in the container.
