10
HDBaseT 4x4 Matrix Switcher User Guide
Connection procedure
1. Connect HDMI from the sources (such as Blu-ray DVD) to the HDMI input ports
on the HDBaseT 4x4 matrix switcher using HDMI cables.
2. Connect local HDMI outputs (1 and 2) to local devices, as required.
3. Connect digital or analog audio outputs to local devices, as required.
4. Connect the HDBaseT port of each output to the HDBT IN port of the
corresponding receiver with a single CAT5e/CAT6 cable using TIA/EIA T568B
terminations at each end.
5. For RS232 control of the switch, connect the RS232 from a control system to the
RS232 port (only pins 2, 3 and 5 are used).
6. Connect RS232 from a control system to each RS232 port to use bi-direction
RS232 via HDBaseT to the receivers, as required.
7. The CM-MT4410-BT-70 can be controlled by the front panel buttons, IR remote
(included), a control system using IR signal via the IR EYE port, RS232, or
TCP/IP.
8. IR outputs are available for use with an IR emitter to allow control of centralized
source equipment from an IR receiver connected to the IR IN on any of the
HDBaseT receiver units.
9. Connect the 48 VDC power adapter to the HDBaseT 4x4 matrix switcher.
System applications
The CM-MT4410-BT-70 matrix switch is useful in any scenario when an HDMI signal
(along with control signals) must be transmitted reliably across greater distances than
is practical using traditional HDMI cables. It can be used in both residential and
commercial applications when centrally locating the source equipment and displaying
HD video in remote locations. The matrix switch allows the sharing of source content
across multiple displays.
Summary of Contents for CM-MT4410-BT-70
