16
HDBaseT 4x4 Matrix Switcher User Guide
Example:
Send command “3R2.” to transfer the IR signal received from zone 2 to IR
OUT port 3.
Note:
When you switch all of the four IR input signal channels to the same IR out
channel, it is not able to control the all controlled device(s) at the same time.
IR carrier enforcing
Only when the IR receiver that is connected with the HDBaseT receiver is with IR
carrier, can the received IR signal be transferred to the IR OUT port of the switcher.
Only when the IR receiver that is connected with the IR ALL IN
port of the switcher is
with IR carrier, can the received IR signal be transferred to the IR OUT port of the
switcher.
When the IR receiver is connected with the HDBaseT receiver, or the IR ALL IN port of
the switcher is not with IR carrier, send the command “%0901.” You are then able to
transfer the IR signal to the IR OUT port.
Control far-end output device from local
When needed to control a remote displayer from local, the IR receiver used must be
with IR carrier. The IR signal is transferred to the corresponding zone connected with
the HDBaseT receiver connected to the IR transmitter. When the IR receiver is
connected to the IR ALL IN port, the IR signal is transferred to all the four IR
transmitters connected to HDBaseT receivers.
Figure 7: Locally control remote devices
IR transmitter
Rx receiver
IR receiver
IR remote
Blu-ray
Summary of Contents for CM-MT4410-BT-70
