Pro Tips
3M VHB Tape
works great if the surface is properly prepared and firm pressure is applied
for over 10 seconds.
Surface Preparation
• Clean the surface
• Ensure the mounting surface temperature is above 50 °F
Reversible
mounting plate
allows for easy use on a wall or table. For table top use,
remove and reverse the mounting plate and install the rubber feet supplied.
To
replace the battery
insert a screwdriver into the latch slot on either side of the
PINPad and pop the cover off the wall plate. Replace the battery and reinstall the
cover onto the wall plate.
Specifications
Physical
Housing Dimensions
Weight with Battery
Mounting Fastener
2.28 x 1.97 x 0.40 inches (5.8 x 5.0 x 1.0 cm)
0.70 ounces (20 grams)
3M VHB™ Tape or #4/#6 screws (Mounting screws not provided)
Environmental
Operating Temperature
Maximum Humidity
32 to 120 °F (0 to 49 °C)
85% relative humidity non-condensing
Sensor Specifications
Frequency
Replacement Battery
Nominal Battery Life
Battery Voltage
Current Draw
Transmitted Indications
433.92 MHz
One Panasonic CR2032
4 to 6 years
3.0 VDC (Nominal), 2.2 VDC (Low)
20 mA (Maximum), 1 uA (Quiescent)
Low Battery, Supervision
Certification
RE652
RE652-CE
UL634, ULC634, FCC, IC
EN50131-1, EN 60950-1, EN300 220, EN301 489, CE, RCM
Specifications subject to change without notice.
01
2019-02-1838-01
941.238.3991
www.ClareControls.com
Original document below
https://bit.ly/2IBUzHe
