English
• This device has been designed
exclusively for use with a vehicular
mounted vision assist camera system. It
should not be used for other purposes.
• Disconnect the vehicle’s negative (-)
terminal when installing wiring.
• Do not attempt to disassemble or
modify this product.
• In the event it is necessary to drill
holes in the vehicle for mounting,
confirm that the drill bit or camera
wiring will not strike or interfere with
piping, gas tank, electrical wiring or
other functional parts of the vehicle.
• Do not rely solely on the monitor
image when reversing the vehicle.
The rear-view monitor is an auxiliary device
meant for confirming the presence of
obstacles to the rear of the vehicle, and is
limited in its range. It should be used only in
conjunction with direct visual observations.
• Always reverse at low speeds.
The rear-view monitor produces a
wide angle image, with the result that
actual distances may be different than
they subjectively appear in the monitor.
• Do not use when the imaging surface
or other parts are malfunctioning.
• When installation and wiring are
completed, confirm that the vehicle’s
horn, brake and warning lights, and
WARNING
CAUTION
other electrical equipment function
properly as designed.
• Install only as directed in the
Installation Manual.
• Install accessory parts as directed.
• When drilling holes in the vehicle
for installation of wiring, always use
insulated grommets in the holes to
protect the wiring.
• If holes are drilled in the vehicle to install
the camera, or when installing wiring,
use silicon sealant to seal any gaps.
• Do not damage or scar the camera
wiring.
• After completing the camera wiring,
use cable clamps or insulation tape to
bundle the wiring together.
• The images produced from the rear-view
monitor are inverted right-left in the same
way as images seen in the vehicle’s
rearview mirrors. The image may differ
depending on the vehicle type.
• Do not use high-pressure car washing
devices around the camera.
The camera is a high-precision
instrument and should not be subjected
to high-pressure water stream impacts.
• Periodically check the tightness of
the installation screws and retighten if
necessary.
3. SPECIFICATIONS
Power source/voltage:
DC 12.0V (9 ~ 16V)
Power consumption:
<100mA
Image sensor:
1/4 inch Color CMOS sensor
Angle of view:
160±3 degrees (horizontal), 120+3 degrees (vertical)
Minimum subject illumination:
0.1 lux (at 50 IRE)
Active pixels:
348,160 (680 horizontal x 512 vertical)
Ingress Protection:
IP67
SN ratio:
46 dB (AGO ON) or better
Operating Temperature:
40° C - +85° C
Audio Input (MIC) Sensitivity:
-38dB ±2dB (0dB=1V/Pa)
Signal to Noise Ratio:
>58dB
Dimensions:
24.31 (W) x 30.81 (H) x 23.11 (D) mm
Note:
Specifications and design are subject to change without notice for further improvement.
3
CC720
