44
NZ503
English
English
Owner’
s Manual
English
Owner’
s Manual
Preset Scan
The Preset Scan receives the stations stored in the
preset memory in order. This function is useful when
searching for the desired station in memory.
1. Touch the
[FM1/2/3/AM]
key to select the desired
band. (FM or AM)
2. Touch the
[
]
key to start the Preset Scan.
The unit starts scanning each station for 10 seconds
sequentially. But the station stored is not a valid
station; the scanning time is only 2 seconds.
3. When the desired station is tuned in, touch the
[
]
key again to stay in that station.
LOC/DX Setting
The DX / LOC setting changes the tuner sensitivity in
order to separate closely spaced stations. This feature
is useful in areas that have many radio stations in
close proximity.
1. Touch the [
] key to switch to LOCAL tuner
sensitivity.
2. Touch the [
] key to switch to DX tuner
sensitivity.
17. HD Radio™ RECEIVER OPERATIONS
This function is available when an HD Radio tuner is
connected.
This unit can control the following HD Radio tuner:
• HD Radio Tuner (THD400)
Note:
• Be sure to turn off the ACC power before connecting/
disconnecting the HD Radio tuner.
• Not all areas offer HD Radio broadcasts
• HD Radio stations may not always broadcast sub
channels
• Volume levels of HD Radio stations may vary. Increase
the volume gradually from the minimal setting after
the channel is selected. Be sure to lower the volume
setting before switching to another mode or channel.
Additional information about HD Radio can be found
at www.hdradio.com
Listening to HD Radio
Note:
Connect THD400 HD Radio
TM
black box to
activate HD Radio function.
1. Touch the Tuner button on the Main menu display.
The HD Radio mode screen will be displayed.
2. Press the [FM1/2/3/AM] button or touch the [Band]
key on remote control to select the radio band. Each
time the button is pressed, the radio reception band
changes in the following order: FM1, FM2, FM3, AM,
FM1...
8
6
7
2
3
9
5
4
1
1. Band Display
2. Bluetooth Status Display
3. Time Display
4. Tune Up
5. Tune Down
6. Preset List Button
7. Direct Button
8. reset Scan Button
9. Setting Button
Seek Tuning
1. Press the [FM1/2/3/AM] button to select the radio
band (FM or AM).
2. Touch the [
] key, and then flick the BIG
Frequency up and down to search for next available
station.
• When flick the frequency up, the station is searched
in the direction of higher frequency.• When flick
the frequency down, the station is searched in the
direction of lower frequency.
Summary of Contents for NZ503
Page 2: ...1 NZ503 1 English NX602 ...