Clarion UNGO MS2105, Owner'S Manual

13

6.

Remote Start in Valet Mode:

Selects whether or not the remote start can be

activated when the security system is in Valet mode.  

8.

Automatic Starting:

Selects the timing interval for the automatic remote start

function.  When the Automatic Starting feature is enabled by the user, the vehicle
will start and run every 2 hours or every hour depending on the programming option
selected for this step.

9.

Engine Run Time:

Selects the length of time the engine will remain running during

remote start operation.

7.2 Entering User Programming

To change any of the user programmable options, follow the steps below:
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2 seconds.

• The siren will chirp, indicating that User Programming has been entered.

3. Press the Valet/Override button the number of times equal to the Option to be

changed.

• The siren will chirp each time the Valet/Override button is pressed.

4. Within 5 seconds, press the transmitter button corresponding to the desired

operating mode for that Option. 

• The siren will chirp a number of times equal to the transmitter button pressed.

5. When finished, turn the ignition OFF to save changes.

7.3 Default Reset for User Programming

The user programmable options may be restored to the factory default setting at any
time.  To restore the factory defaults follow the steps below:
1. Turn the ignition ON.
2. Within 5 seconds, press the Valet/Override button 2 times and hold for 2 seconds.

• The siren will chirp, indicating that Programming has been entered.

3. Press transmitter button 3.

• The siren will chirp 6 times indicating the reset signal has been received, and User

Options have been reset to factory default.

MS2105 owner.qxd  8/25/2003  4:21 PM  Page 13